Reverse lights position sensor?

[04stangman]

It's that easy unless you have the switch that is mounted on the transmission itself rather than the steering column

Well, it was easy but not super easy. I think the reason it was not working properly is because it was mounted to wrong spot on the steering column. So, I drilled out the holes ans extended them and slid the sensor to the right about a half inch and it worked!!!! You guys are genuineness! Thanks a bunch.

[flyboy2610]

Nah. Not geniuses. (But you may think so if you wish! )
There aren't too many problems that come up that haven't been dealt with before, so after awhile, ya just know.
Glad to hear you got everything working properly!

[westernkansas]

thanks guys, I also have no back up lights so ill try to adjust the saftey switch. but on mine I have to hold the shifter up to start so hopefully I will kill two birds with one stone. I really don't want to mess with the linkage if i don't have to....LMC has new switches for I think 70 bucks. has anyone ever pulled one from salvage yard and have luck with it working.?

[6T7Merc]

Even with the tranny switch its easy. Its held on by two screws which you loosen off and move slightly to either side.