
TSS Side-----------Harness
Red/Black Stripe-----------Lt Green
Yellow/Black Stripe-----------Yellow
Lt Green-------2x Red/Black Stripe
Since I bought the truck I have no reverse lights, no emergency flashers(busted switch), no rear right turn signal, & no horn(horn & relay are good). Recently after installing in a new Grant Steering wheel, my brake lights went out. They always worked, they could've gone out before the steering wheel went on but I didn't notice until after the install. The driving lights work at nite, and the rear left turn signal works but no brake lights? I have a new TSS, and just ordered a new Brake Light switch that arrived today. I was ordering other stuff so just incase I ordered a Brake Light switch for $6.
So when I install the new TSS, should I match up the Red/Black Striped wire to each other? I think I've got more wire chasing to do from the looks of it? Any advice is appreciated!
