EZ Wiring Harness

[bill69f100]

I put mine in last year. It is the 22 circuit harness. It comes from both.I blew my 50A fuse and the guage said I was over charging. I was still driving when it happened. I checked and had 14.56 which on mine was normal. I did get the schematic for my 69' which helped alot. The one they give you is for GM. It took me about 37 hours to get mine in. Soldering is the best way to go. I used rubber grommits in the firewall and flexloomed the rest. I just started merging a harness from a 05' CVPI into the truck.

[usmcjones1988]

does anyone know what wire goes to the I post on the starter solenoid for the EZ wire harness?

[F100builder]

I have the EZ harness and there is NO wire on the "I" terminal of the solenoid.

[Thunderfoot]

For the "I" terminal on the Starter Solenoid it is just a wire from there "I terminal" to the (+) of the coil... it is not in the harness so to speak, so wouldn't be in the EZ harness... This wire from the Starter Solenoid is to give the ignition coil full 12V during cranking to help start the engine when it is cold, it is activated by the Starter Solenoid when the "S" starter wire is activated and shuts off the same way...

[usmcjones1988]

does anyone know where the other end of the dome light wire is I can only find the one wire that goes to the light it self not the switch one

[Thunderfoot]

does anyone know where the other end of the dome light wire is I can only find the one wire that goes to the light it self not the switch one

There is only one wire going to the Dome Light and it is connected inline with the door switches and to the light switch. See diagram here http://www.fordification.com/tech/wirin ... ycargo.jpg

[usmcjones1988]

i tried wire up my alternator and voltage regulator the why and EZ manual said to and im not getting anything at the battery, has this happened to anyone else?