Blower motor

mjhaltom · Post by **mjhaltom** » Mon Nov 05, 2007 8:43 pm

Where does the black ground wire go. What screw did it ground to from the factory?

fordman · Post by **fordman** » Mon Nov 05, 2007 8:53 pm

the factory had it on top of the case on the metal housing. i just went out and looked at a spare i have.

1971ford · Post by **1971ford** » Mon Nov 05, 2007 8:54 pm

there is a very small whole way up in the top right of the firewall. if you look at it under the hood, you will see the other side of the whole right next to or somwhere close (i forget) to the passenger inner fender bolts (the ones bolting into the cowl or firewall area). it is very hard to see at first if you havent allready spotted it from the interior.
i just grabbed a random screw that fit. and put a nut on the other end (very hard to do, because of the tight spot it is in)

i hope that confusing mess helps

1971ford · Post by **1971ford** » Mon Nov 05, 2007 8:59 pm

fordman wrote:the factory had it on top of the case on the metal housing. i just went out and looked at a spare i have.

really?!

psshhh , i went through the trouble of screwing it into a very tight spot. where exactly is it on the metal houseing? are you guys talking about a heater or heater/ac?

fordman · Post by **fordman** » Mon Nov 05, 2007 9:34 pm

i was talking about heat only boxes.

Post by **FORDification** » Mon Nov 05, 2007 9:57 pm

Since a picture's worth a thousand words:

mjhaltom · Post by **mjhaltom** » Mon Nov 05, 2007 10:43 pm

Thanks to everyone! That is exactly what I needed!

The FORDification.com Forums

Blower motor

Blower motor

re: Blower motor

re: Blower motor