Guage cluster problems

Memphobanjo · Post by **Memphobanjo** » Mon Nov 17, 2014 11:05 pm

My water temp and oil pressure gauges peg out when connected I have put new sensors in also have tested the gauges by alligator clipping the wire at the sensor to ground and the gauges peg out when tested which should be correct but still can't figure out why they are not working any ideas?

tac · Post by **tac** » Tue Nov 18, 2014 11:00 am

There is a Voltage Regulator on the Instrument cluster that could be your problem.

Nitekruizer · Post by **Nitekruizer** » Tue Nov 18, 2014 1:26 pm

tac wrote:There is a Voltage Regulator on the Instrument cluster that could be your problem.

There are some threads on here about it. Look up "IPVR" or "Instrument Panel Voltage Regulator".

Memphobanjo · Post by **Memphobanjo** » Wed Nov 26, 2014 1:18 am

I ordered a ipvr today old one was busted up and not working I'll update when I install thanks!

Memphobanjo · Post by **Memphobanjo** » Thu Nov 27, 2014 7:53 pm

Okay I ordered a new ipvr from lmc put it on and nothing works put old one back on and back to original problem is lmc known for shipping bad parts?

duaneo · Post by **duaneo** » Fri Nov 28, 2014 2:49 am

I don't know if this thread is going to make you feel better or worse.

http://www.fordification.com/forum/view ... a&start=15

Take a look, see if it helps.

Cheers,
Duane

The FORDification.com Forums

Guage cluster problems

Guage cluster problems

Re: Guage cluster problems

Re: Guage cluster problems

Re: Guage cluster problems

Re: Guage cluster problems

Re: Guage cluster problems