spark, working, not working

Charging, starting, lighting, gauges, HVAC

Moderators: FORDification, Thunderfoot

Post Reply
davehdicus
New Member
New Member
Posts: 3
Joined: Sat Feb 18, 2012 8:44 pm

spark, working, not working

Post by davehdicus »

my 1969 F-250 390cid. Runs good till it warms a little then no spark . wait an hour starts drive to store drive around town parkiy. go out next morn fires right up, idles a few min. than dies, check no spark. new coil, dist. parts. voltage reg, start relay. the only thing I havent changed is the alt. have a new one just havent tried it yet. nww wirs from ign. switch. , perplexed???
User avatar
duaneo
Preferred User
Preferred User
Posts: 269
Joined: Thu Aug 21, 2014 1:39 pm
Location: California, Oakland

Re: spark, working, not working

Post by duaneo »

I don't have any firm advice, but my ignition issues were due to the condenser grounding out. I am visualizing a situation where a wire changing in shape a little when it changes in temperature. Take a look under your distributor cap to make sure nothing is shorting out and effectively causing the points to be bypassed.

Also, for what it was worth, I was turning my engine over in the dark, which made it easy to see the spark, or lack thereof when I pulled a plug wire loose.

Cheers,
Duane
1971 F100 - Ugly on the outside, but purty under the hood...
1968 Chevrolet Impala - Family car since 1970, My car since I was 16, in need of bodywork/paint, but otherwise straight.
2004 Mini Cooper S - Daily driver and grown up go-kart
fordman
100% FORDified!
100% FORDified!
Posts: 22329
Joined: Sun Aug 28, 2005 8:17 pm
Location: Kansas, Ottawa
Contact:

Re: spark, working, not working

Post by fordman »

Check power going to coil when this happens. Could be loose ignition switch too.
Post Reply