So I have attached my Pertronics to the little dangling wire from the cab in the pictures below (Red wire connected to it). I wanted it to have a full 12 volts power instead of running off the coil with the resistance wire. I have looked at alot of diagrams and see this is for an air conditioner compressor or the throttle solenoid.
I have tested and found the it gets 12 volts at Run and 12 volts at Start. Is there any reason why it should not be a power source for my Pertronics? Opinions please.....
DSCN0705.jpg
DSCN0704.jpg
Dont make fun of the messy wires I am not done with the planning phase yet. Once all is planned out I am gonna clean it up!!!
You do not have the required permissions to view the files attached to this post.
